Product Code: SA-SA-026
Features:
- Adjustable timer from 1~60 secs via a pot on board.
- NO/NC switch trigger.
- Compact design: 13/16”x2 ”x ” (30x58x16 mm)
- Operating voltage: 12~24 volts AC or DC.
- Current: 2mA (stand-by), 75mA (active).
- Relay output: Form C (SPDT) via terminal blocks.
- Contact rating: 2A@24VDC.
- With built-in buzzer output (100mA@24VDC).
- Includes double-sided foam tape.
|
Product Code: SA-SA-025
Features:
- Timer can be set from 1 second to 60 minutes
- Can be triggered via a N.O. positive (+) trigger input signal or a N.C. negative (-) trigger device or by powering up the unit
- Relay can be programmed to activate at the start or at the end of the timing cycle
- Relay can also be set to activate for one second at the end of the timing cycle
- Relay can be programmed to pulse (flash) or be steady on
- Built-in reset function to manually reset timing cycle
- Form-C relay, contacts rated 8A @ 120VAC/24VDC
- LED indicates relay is energized
- 12VDC/24VDC operation (auto sensing)
- Current draw – Less than 1mA (standby) or 50mA (relay energized)
- Board measures 2-7/8” x 2-1/2” (73 x 63 mm)
- Functions programmed via DIP switches – no jumpers to cut
|
Product Code: SA-SR-2224-C5
Features:
- Two separate sets of Form-C dry contacts.
- Perfect for a variety of general switching purposes.
- Can be connected for load switching, dry contact, latching output, reverse polarity, line seizure, and other uses.
- 6/12/24 VDC operation, programmable by on-board jumpers.
- Red LED indicates relay is energized.
- Large terminal blocks for easy installation.
- Small size, easily fits inside alarm panel enclosures or other hidden areas.
- Foam mounting tape included.
|
Product Code: SA-ST-1206-1.5A
Features:
- Convert low-voltage AC input power to low-voltage DC output power.
- Regulated and filtered output voltage.
- Short circuit protection.
- Thermal protection and compensation.
- Built-in backup battery charger.
- Switches automatically in case of power loss.
- Fused protection for battery charger.
- 2 LEDs to indicate AC power input and DC power output status.
- Compatible with lead acid or gel-type rechargeable battery.
- Reverse polarity protected.
- Includes foam tape and battery terminals for easy installation.
|
Product Code: SA-ST-1206-2A
Features:
- Convert low-voltage AC input power to low-voltage DC output power.
- Regulated and filtered output voltage.
- Short circuit protection.
- Thermal protection and compensation.
- Built-in backup battery charger.
- Switches automatically in case of power loss.
- Fused protection for battery charger.
- 2 LEDs to indicate AC power input and DC power output status.
- Compatible with lead acid or gel-type rechargeable battery.
- Reverse polarity protected.
- Includes foam tape and battery terminals for easy installation.
|
DVR / NVR System
